Epoxy Resin Flooring Deposits and Payment Terms: How To Protect Cashflow
If you do epoxy resin flooring work, the cashflow pressure normally comes from the same place: the job starts moving before the money is collected properly. Materials, labour, scheduling risk, and client drift all sit on your side if the terms are soft. This page is about tightening that up.
Why epoxy resin flooring businesses get squeezed
The floor looked perfect when you left. Three months later the client sends photos - a section has lifted in the corner near the drainage point. The concrete under it was wet. You didn't moisture test before application. You're replacing a $4,000 floor at your own cost. Epoxy resin flooring is excellent high-margin work with a very specific set of failure modes. Every one of them is preventable with proper surface preparation and documentation.
Project-based work gets squeezed when the deposit is too soft. Materials, labour, subcontractors, freight, and scheduling risk all hit before the final invoice. Good payment terms stop you funding the whole job out of your own pocket.
The right deposit reflects exposure, not nerves
- 10% deposit: small straightforward jobs with light pre-start risk.
- 20% deposit: most standard jobs with moderate materials and booked labour exposure.
- 25% to 30% deposit: larger projects, custom materials, longer lead times, or multi-stage delivery.
The clean test is simple: if the client disappeared after approval, would the deposit leave you carrying a stupid amount of risk? If the answer is yes, the deposit is too soft.
How to structure payment terms on bigger jobs
Once the work runs beyond a very short attendance, stage payments are usually cleaner than leaving almost everything to the end.
| Project type | Deposit | Stage 1 | Stage 2 | Final |
|---|---|---|---|---|
| Standard project job | 20% | 40% at mobilisation or materials on site | 25% at clear midpoint | 15% on completion |
| Materials-heavy project | 25% | 35% when materials are committed | 25% at install start | 15% on handover |
| Larger multi-stage job | 20% to 25% | 30% at site prep complete | 25% at install midpoint | 20% on completion |
The exact split moves by job, but the rule does not: if your cost base is getting ahead of billing, the structure is wrong.
How to actually collect the money
- Use payment links for deposits and progress claims.
- Use card collection where speed matters more than shaving every fee.
- Invoice at the milestone, not days later when admin catches up.
- Use direct debit if the work repeats.
Weak collections are often just weak structure showing up late.
If the deposit is weak, the rest of the job usually gets messy too.
Tighten the terms first, then layer in faster collection and finance only where it genuinely helps.
Read: Offering Finance for Epoxy Resin Flooring Jobs ->Frequently Asked Questions
For most jobs, the deposit should cover real pre-start exposure like materials, scheduling, labour commitment, and lead time. Smaller jobs may suit around 10%, while more exposed work often needs 20% to 30%.
Yes. Once the scope runs beyond a small straightforward attendance, the billing should move in stages so your cashflow does not fall behind the job.
Taking a soft deposit and leaving too much to final payment. That is how a job can look profitable on paper but still pressure cashflow in real life.
When affordability is the real blocker on a larger quote. Tight payment terms should come first, then finance can help the right client approve the proper scope without turning you into the lender.